As an enterprise, the normal operation of the machine is very necessary. In order to make the finished product look better, the quality is better, and reduce the loss caused by man as much as possible, the winder should do the following work well in the process of using: 1, check that the conductor of the upper working procedure is red and blackened; 2, confirm that the root number of the upper working procedure is correct, the direction is correct, the marking is complete and the line arrangement is neat; 3) verify that the packing belt is in good packing and the marking and specification are consistent with the technological requirements; 4, check the actual operation of the production in accordance with the requirements of the process card; 5, check the appearance of the strand is round, tight molding is good, there is no missing stock, jumper, missing package, etc. 6, inspection Check the installation capacity of this process to meet the requirements of the upper plate, the wire disk is in good condition and the line is neatly arranged. The wrong direction of winch, the causes and elimination methods of wire arrangement confusion: in the course of the use of winch, due to improper operation or other natural factors, the twisting direction of winch is wrong, the pitch of winch is not up to standard, and there are even more chaotic wire pressing and so on. For the wrong direction of hanging, the pitch of hanging is not up to standard (mainly too large), mainly because of the error of judgment, and the direction of hanging is determined as shown in figure 7-1. When operating, the operator should strengthen the sense of responsibility, strictly carry out according to the process card, and strengthen the flow inspection to prevent the emergence of man-made bad products and waste products. . If the line arrangement is chaotic and pressed, it is basically caused by the following situations: hanged products are generally supplied in a disk. The large section should be arranged one by one, especially the bottom line should be arranged neatly. When the line is turned around, special attention should be paid to the fact that there is not much gap between the upper and lower layers, the row distance should be appropriate, and it is easy to press the line if it is too large. In view of the above situation, we can take the following methods to deal with: first, we should adjust the tension of the receiving line, when the manual line arrangement, one can be able to arrange the appropriate, second, according to the diameter of the wire core to replace the row pitch, the first floor is the key, must be arranged neatly When adjusting the layer, manual wiring should be carried out to ensure the quality of the line arrangement. Third, strengthen the sense of operational responsibility to observe the quality of line arrangement at any time, find problems should be adjusted in time, pay attention to fixed two wire heads and left edge distance.