There are many safety accidents in the use of high-speed winch, and many people often ignore some attention details in the use of industrial machines, so we should pay more attention to it, such as ground harness copper machine, wire binding machine, copper winder, winch machine, extruder, pullout machine, etc., which are also widely used in industrial manufacture. Then I would like to explain to you what to pay attention to: whether the safety device is complete, whether the operating components are flexible and reliable, and whether they are loose. Close the protective cover, check if there is anyone near the machine and other unsafe factors, ring the alarm first and turn it on, do not use the click instead of the normal start for a long time The equipment runs. Often check and fasten the screws in the cover of the wire tray to prevent loosening. Check that the top of the release frame is tight and locked after the line is changed. When the equipment is in operation, it shall not cross the running part and no one shall stay or walk in the dangerous area of the prescribed equipment. When the equipment is running, it is necessary to observe the wire storage of the wire release disk, and it should be observed at the head or tail of the winch. Generally speaking, it should not be observed in the middle of the winch to prevent accidents. When the equipment is in operation, it is not allowed to change gears, wipe equipment and clean. When the equipment is running, we must constantly observe the operation of the equipment, find anomalies, and stop and deal with it immediately. Equipment failure does not rule out driving . When using hoist, no skew crane, hoisting or overloading, hanging belt should be regularly inspected, if damaged should be stopped immediately replaced. When there is a kink in the ground winch of the winch machine, the die holder should be prevented from being squeezed out. Keep the workplace clean and clear. If there is waste wire and sundries under the winch, you can only drive after removal. The wire plate is arranged neatly according to the prescribed area. Empty disk is shipped out of the passage in time. Pay attention to the source of fire and prevent fire. As soon as the equipment parts are found to be overheated and smoke, stop immediately and report to the personnel concerned.